Power CD+G Burner 2 Help

Settings dialog box allows to adjust how Power CD+G Burner works.

Burner settings

Use internal burning engine enables primary burning mode. It has two operating modes, Disc-at-once and Session-at-once. Usually Power CD+G Burner automatically selects the best operating mode.

Try using SPTD if possible enables SPTD (SCSI Pass Through Direct) layer for device access. It should be used if you are experiencing device access problems or conflicts with other software. Please make sure that you install SPTD when installing Power CD+G Burner, otherwise this option will not be available.

Use CDRDAO burning engine enables alternate burning mode and may be used if internal mode is not working correctly. Settings in this section also should be set automatically by the program.

Use maximim write speed as default causes Power CD+G Burner to select the highest burning speed available -- this should be fine with most modern drives, but if you prefer to burn at lower speed you may check this option off.

FreeDB settings

Power CD+G Burner uses FreeDB internet database to retrieve track names. You need to allow Power CD+G Burner to access the Internet (this is if you are using firewall software). If you are getting listings for some discs and others are not displayed, then probably latter are not available in FreeDB database -- it contains many discs, but not all. You may try changing the FreeDB server to Tracktype.org, maybe your disc will be listed there.

If you are in a network behind a firewall you may need to define a proxy access for FreeDB -- enable Use HTTP proxy and enter server name and port number.

Enable multisession disc detection should be enabled when ripping discs recorded in multisession mode. If you are unable to rip the last track of the disc try enabling this option.

Check for updates on exit will display the prompt to check for the new version of the program when closing down.