Lyrics aren't showing up on screen

[rebelbrad]

I've always downloaded karaoke music from the internet and used Alcohol 120% to burn the songs onto a CD to play on our karaoke machine, in the past. I recently purchased a new Dell laptop, though, and had software issues with Windows 7 and my old karaoke software so I purchase Karaoke CD+G Creator with the Power CD+G Burner.

Tonight, I walked through the tutorial and created a song, removed the vocals, and added the lyrics... and it worked perfectly in Karaoke CD+G Creator in preview mode. When I burn the bin file onto a CD+R using Power CD+G Creator and play it on my karaoke machine, though, I can only hear the music (can't see the lyrics).

In the past I've used only CD-R's... I just happened to run out and got CD+R's instead. Is there a difference in the two as to which I should use for this or am I doing something wrong?

Thanks!

[adam]

What is the manufacturer name of the CD/DVD drive you are using to burn the discs?

[rebelbrad]

I can't find that information in my Control Panel under Hardware (and it doesn't show on my laptop). It's just the default cd/dvd burner of a new Dell Studio 16 laptop. My last Dell (Inspiron E1505) burned karaoke cds fine so I think their cd/dvd burners should (hopefully) handle burning the information.

[rebelbrad]

I just bought some CD-Rs and it didn't seem to help. The audio is fine, it's just the lyrics.

[rebelbrad]

Here's my log file if that helps, too:


FindDevice:FindCallback(): Probing SCSI address 0:0:0:0 for CD/DVD device... OK!
FindDevice:FindCallback(): Found CD/DVD device 'HL-DT-ST' 'DVD+-RW GA31N ' 'A102'
FindDevice:FindCallback(): With 1048576 UCHAR(s) of cache
FindDevice:FindCallback(): Reads: CD-R: Yes, CD-RW: Yes, DVD-ROM: Yes, DVD-R: Yes, DVD-RAM: Yes
FindDevice:FindCallback(): Writes: Test mode: Yes, CD-R: Yes, CD-RW: Yes, DVD-R: Yes, DVD-RAM: Yes
FindDevice:FindCallback(): Reads: DVD+RW: Yes, DVD+R: Yes, DVD+R DL: Yes, Writes: DVD+RW: Yes, DVD+R: Yes, DVD+R DL: Yes
Probing supported write modes... OK!
Track-At-Once: Yes, Session-At-Once: Yes, Disc-At-Once PQ: Yes, Disc-At-Once raw P-W: Yes
OK!
Getting current CD/DVD speeds... OK!
SessionAtOnceRawRawPWEx:main(): Current read speed 4234 KBps (4234 maximum)
SessionAtOnceRawRawPWEx:main(): Current write speed 4234 KBps (4234 maximum)

Settings:
BurnEngine:1
TempFolder: C:\Users\Brad\AppData\Local\Temp\
Driver:generic-mmc
UseMaxWriteSpeed:N
DontInterleave:N
NoInterleaving:N
DontCorrectErrors:N
TransportMode:1
RW_RAW:Y
Force:N
CurrentDevice:0
InternalMode:1

[adam]

Please switch to CDRDao mode, and enable MMC_RAW driver in the Settings dialog box.

[rebelbrad]

Thanks! that fixed it...