KPro Question

[KayJay2010]

OK here is my setup.

I am running a a laptop with a splitter that goes to a 32" flat panel display for the audience and a second 24" flat panel that is for the singer. Both are using the VGA cable and hook into the laptop. Have the laptop set at 1024X768 and using the laptop's Intel Dual Display Clone mode.

I don't want the singer or the audience to see the application side, only the screen with lyrics and the upcoming singer.

I have tried the setting for dual displays in the KPro but it doesn't help that situation.

Is it even possible to do this? I have searched the forums and found nothing talking about this. I have seen other KJ's do this with other programs but I really like KPro the best.

Any help would be great.

[hornet59]

In your laptop display properties under the settings tab, in the display drop down selection you will need to select display 2 and make sure that "extend my windows desktop onto this monitor" is checked. Then click on apply and make sure that the check mark remain. Sometimes even after clicking on apply, the check mark disappears. If this happens you will need to check it again and click on apply. Hope this helps

[KayJay2010]

Thanks for the tip.

I will try that later today and let you know it all comes out.

In your laptop display properties under the settings tab, in the display drop down selection you will need to select display 2 and make sure that "extend my windows desktop onto this monitor" is checked. Then click on apply and make sure that the check mark remain. Sometimes even after clicking on apply, the check mark disappears. If this happens you will need to check it again and click on apply. Hope this helps